quench flow velocity
本帖最后由 oliver 于 2014-6-10 11:11 编辑请教:
最近看到国外某公司标准上一段话:Achieving uniform martensite microstructure specification typically requires an impingement quench flow velocity on the entire surface of a part in excess of 0.76 m/s (2.5 ft/sec) for water and 1.07 m/s (3.5 ft/sec) for oil.
不知其中“quench flow velocity”对应国内什么术语或概念,也不明白“0.76 m/s (2.5 ft/sec) for water and 1.07 m/s (3.5 ft/sec) for oil”对应国内什么速度或概念。 工件表面淬火液流动速度,如果非要计算,我认为用流量/表面积/淬火液在表面的厚度 “工件表面淬火液流速”,有道理,谢谢! 淬火流速,从字面上理解就是这样,不知道理解的对不对,
页:
[1]